Victron Phoenix Smart charger 12/30 (1+1) IP43 120-240V

Victron Phoenix Smart charger 12/30 (1+1) IP43 120-240V

Victron Phoenix Smart charger 12/30 (1+1) IP43 120-240V

The new Victron Phoenix Smart Charger 12/30 (1+1) IP43 120-240V has two outputs. The first output is an adjustable five-step charger capable of charging 30A at a 12V system voltage. The second output, limited to approximately 3A with a slightly lower output voltage, is intended as a maintenance charger for a starter battery. For voltage and temperature compensated charging, the wireless Smart Battery Sense (SBS050100200) can be ordered. Bluetooth Smart enabled: Use a Bluetooth-enabled smartphone, tablet, or other device to monitor voltage and current, change settings, and update the charger when new features become available. Automatic charge compensation: By slightly increasing the output voltage as the DC current increases, the charger automatically compensates for voltage loss through DC cables. Adaptive 5-step charge algorithm: bulk – absorption – reconditioning – buffer – storage. The Phoenix Smart Charger features the renowned Victron Energy adaptive battery management system, which can be pre-set for various battery types. The adaptive function automatically optimizes the charging process based on battery usage. The right amount of charge: adjusted absorption time. When the battery is slightly discharged (when the charger is connected to the mains), the absorption time is kept short to prevent overcharging and excessive gassing. After deep discharge, the absorption time is automatically extended to fully charge the battery. Limiting damage from excessive gassing: the safe battery mode. If, to shorten the charging time, a high charging current and an increased charging voltage are selected, the Phoenix charger will limit the voltage rise rate after the gassing voltage is reached. This prevents excessive gassing in the final phase of the charge cycle. Reduced maintenance and aging when the battery is not used: the storage mode. When there is no discharge for more than 24 hours, the battery switches to storage mode. The voltage is then reduced to 2.2V/cell (13.2V for a 12V battery) to minimize gassing and corrosion of the positive plates. Once a week, the voltage is increased to absorption level to recharge the battery. This prevents stratification of the electrolyte and sulfation of the plates, a major cause of premature battery failure. Also suitable for charging Li-ion (LiFePO₄) batteries. On/off control of the charger can be implemented by connecting a relay or an open collector optocoupler output of a Li-ion BMS to the remote control port of the charger. Alternatively, full control of the voltage and current is possible via Bluetooth. Fully programmable charge algorithm The charge algorithm can be configured using Bluetooth or the VE.Direct interface. The mode button allows you to select three pre-programmed charging algorithms. Remote control on/off The remote control on/off consists of two terminals: Remote control H and Remote control L. A remote control on/off button or relay contact can be placed between H and L. It is also possible to raise terminal H or lower terminal L. VE.Direct interface For connection to the Color Control panel, laptop or other equipment. Programmable relay Can be set using the VE.Direct interface or a Bluetooth device in case of an alarm or pre-alarm.

We'd be happy to provide you with more information about this product. Please contact us.