Victron Smart charger 48/13 (1) IP43 120-240V

Victron Smart charger 48/13 (1) IP43 120-240V

Victron Smart charger 48/13 (1) IP43 120-240V

The new Victron Phoenix Smart charger 24/25 (1+1) IP43 230V has two outputs. The first output is an adjustable five-step battery charger capable of providing a charge of 25A at a 24V system voltage. The second output, limited to approximately 3A with a slightly lower output voltage, is intended as a maintenance charger for a starter battery. For charging with voltage and temperature compensation, the wireless Smart Battery Sense (SBS050100200) is available to order. Bluetooth Smart enabled: Use a Bluetooth-enabled smartphone, tablet, or other device to monitor voltage and current, change settings, and update the battery charger when new features become available. Automatic charge compensation: By slightly increasing the output voltage when the DC current increases, the battery charger automatically compensates for voltage loss caused by DC cables. Adaptive 5-stage charging algorithm: bulk – absorption – reconditioning – buffer – storage. The Phoenix Smart Charger features the renowned Victron Energy adaptive battery management system, which can be pre-set for different battery types. The adaptive function automatically optimizes the charging process depending on battery usage. The right amount of charge: adjusted absorption time. In the event of low battery discharge (if the charger is connected to the mains), the absorption time is kept short to prevent overcharging and excessive gassing. After a deep discharge, the absorption time is automatically extended to fully charge the battery. Damage limitation due to excessive gassing: the safe battery mode. If a high charging current and increased charging voltage are selected to shorten the charging time, the Phoenix charger will limit the voltage rise rate after the gassing voltage is reached. This prevents excessive gassing in the final phase of the charging cycle. Reduced maintenance and aging when the battery is not in use: the storage function. When no discharge occurs for more than 24 hours, the system switches to the storage function. The voltage is then reduced to 2.2V/cell (26.4V for a 24V battery) to minimize gassing and corrosion of the positive plates. Once a week, the voltage is raised to the absorption level to recharge the battery. This prevents stratification of the electrolyte and sulfation of the plates, a major cause of premature battery failure. Also suitable for charging Li-ion (LiFePO₄) batteries. It is possible to implement on/off control of the charger by connecting a relay or an open collector opto-coupler output of a Li-ion BMS to the remote control port of the charger. Alternatively, full control of voltage and current is possible via Bluetooth operation. Fully programmable charging algorithm. The charging algorithm can be configured using Bluetooth or the VE.Direct interface. Three pre-programmed charging algorithms can be selected using the mode button. On/Off Remote Control The on/off remote control consists of two connections: Remote Control H and Remote Control L. A remote control on/off button or relay contact can be placed between H and L. It is also possible to raise connection H or lower connection L. VE.Direct interface For connection to the Color Control panel, laptop, or other equipment. Programmable relay Can be configured using the VE.Direct interface or a Bluetooth device in the event of an alarm or a pre-alarm.

We'd be happy to provide you with more information about this product. Please contact us.