Victron SmartSolar MPPT 150/85-Tr VE.Can (12/24/36/48V)

Victron SmartSolar MPPT 150/85-Tr VE.Can (12/24/36/48V)

Victron SmartSolar MPPT 150/85-Tr VE.Can (12/24/36/48V)

The Victron SmartSolar MPPT 150/85 12/24 (autoselect) / 36/48V is a solar charger for 3600W at a 36V system voltage and 4900W at a 48V system voltage for 12/24/36/48V systems. The maximum nominal PV power output of the solar charger at a 12V system voltage is 1200W, 2400W at a 24V system voltage, 3600W at a 36V system voltage, and 4900W at a 48V system voltage. The maximum PV open circuit voltage of this solar charger is 150V The maximum PV open circuit voltage of this solar charger is 150V The SmartSolar solar charge controllers have a programmable battery charging algorithm, and standard Bluetooth Smart built in to be able to set up the solar charger and monitor solar yield. Using VE.Can or Bluetooth, up to 25 solar chargers can be connected in series and connected to a Color Control GX or other GX device. Each controller can be managed individually, for example with a smartphone or iPad (Bluetooth) or with a Color Control GX (VE.Can) and then also on the VRM website. Bluetooth Smart built in: no dongle required The wireless solution to set up, monitor and update the controller via Apple or Android smartphones, tablets or other devices. VE.Direct For a wired data connection to a Color Control panel, Venus GX, PC or other devices. Ultra-fast Maximum Power Point Tracking (MPPT) Especially in cloudy conditions when light intensity is changing continuously, an ultra-fast MPPT controller can improve energy harvest by up to 30% compared to PWM charge controllers and by up to 10% compared to slower MPPT controllers. Advanced Maximum Power Point Detection in case of variable shading In case of variable shading, the power-voltage curve can contain two or more maximum power points. Conventional MPPTs tend to use a local MPP, which may not be the optimal MPP. The innovative BlueSolar algorithm always maximizes energy harvest by using the optimal MPP. BatteryLife: intelligent battery management If a solar charge controller cannot fully recharge a battery within a single day, the result is often that the battery constantly fluctuates between 'partially charged' and 'fully discharged'. This state (lack of regular full charging) will irreparably damage a lead-acid battery within a few weeks or months. The BatteryLife algorithm monitors the battery’s state of charge and, if necessary, slightly increases the load disconnect level day by day (by disconnecting the load earlier) until the harvested solar energy is sufficient to charge the battery close to 100%. From that moment on, the load disconnect level is modulated so that the battery is charged close to 100% approximately once per week. Programmable battery charge algorithm Every morning, as soon as the sun comes out, the charge controller starts a new charge cycle based on a three-step charging process: Bulk – Absorption – Float. The battery charge algorithm is programmable with a set of default settings or user-defined settings. Internal temperature sensor Compensates absorption and float charge voltages for temperature. Remote on/off For connection to a VE.BUS BMS, for example. Programmable relay Can be programmed (via a smartphone, for example) to be activated by an alarm or other events. Optional: connectable LC display To do this, remove the rubber seal protecting the plug on the front of the controller and connect the display to it.

We'd be happy to provide you with more information about this product. Please contact us.