SCHUKO 12/1200 230V VE Direct Converter
Inverter 12/1200 230V VE.Direct SCHUKO Applications The new generation of VE.Direct inverters delivers more power per kilo and retains it better at high temperatures. 1150 W continuous with a built-in Schuko socket: plug in and go, without fixed AC cabling. * Motorhomes, vans, and service vehicles on 12 V * Sloops, motor yachts, and smaller work vessels * Garden sheds, chalets, and off-grid accommodations * Mobile workstations and measurement setups * Backup for equipment that must continue operating during a power outage Power and starting behavior * 1150 W continuous at 25 °C, 1000 W at 40 °C * 1200 W for one hour (cold start) * 1600 W peak power for 15 seconds for starting currents of motors, pumps, and power tools * Pure sine wave, suitable for sensitive electronics * Full bridge with toroidal transformer; Short-circuit proof and protected against overheating due to overload or high ambient temperature * Maximum efficiency 91% ECO mode If the load drops below the set threshold, the inverter switches to standby and periodically scans whether there is demand again. The minimum generating power is 15 W by default and the scanning interval is adjustable. Consequently, the no-load power drops from 10 W to 1 W. The correct setting depends heavily on the type of load: inductive, capacitive, or non-linear. Expect a brief on-site adjustment. Battery monitoring and shutdown * Input voltage range 9.2 – 17 V * Low battery voltage shutdown default 9.3 V, adjustable * Restart and alarm at 10.9 V, battery charged detection at 14 V, both adjustable * Dynamic shutdown: the shutdown level follows the load, configurable per battery type in VictronConnect * Protected against short circuit, overload, over- and under-battery voltage, over-temperature, and excessive DC ripple voltage. Do not use dynamic shutdown in an installation where other consumers are also connected to the same battery bank: the inverter cannot account for this load and will shut down prematurely with an undervoltage alarm. VE.Direct port * Read out and configure via VictronConnect on a smartphone or tablet using a VE.Direct Bluetooth Smart dongle * Connection to a PC via a VE.Direct-to-USB interface cable, or with a GX device * Adjustable: output voltage 210 – 230 V, frequency 50 or 60 Hz, ECO threshold and scan interval, alarm and trip levels, dynamic trip curve per battery type * Monitoring of input and output voltage, load percentage, and alarms; firmware update via the app Connection and mounting * Schuko socket (CEE 7/4) on the device * DC side on screw terminals, maximum cable cross-section 35 mm²; battery cables are not included * Connection for an external on/off switch on the two-pole plug, or between the battery positive terminal and the left contact thereof * Battery alarm for excessive or low battery voltage, acoustic and visual, with relay for remote notification * Protection class IP21; Dry, indoor installation only * Operating temperature -40 to +65 °C with fan cooling; above 40 °C, power decreases by 1.25% per °C. Can be ordered directly with this * Victron VE.Direct Bluetooth Smart dongle (https://shop.top.systems/monitoring-controle/draadloos/victron-ve-direct-bluetooth-smart-dongle.html) (ASS030536011) — read out and configure via VictronConnect. Category: Monitoring & control > Wireless (https://shop.top.systems/monitoring-controle/draadloos/) At 12 V, well over 100 A flows through the battery cables at full power. Select cross-section, crimp lugs, and fuse based on the cable length in the categories Battery cables (https://shop.top.systems/installatie/kabels/accu/), Crimp lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/), Fuses (https://shop.top.systems/beveiligen-schakelen/zekeringen/), and Fuse holders (https://shop.top.systems/beveiligen-schakelen/zekeringhouders/). Related products * Inverter 12/1600 230V VE.Direct SCHUKO (https://shop.top.systems/omvormen-laden/omvormen-dc-ac/omvormer-12-1600-230v-ve-direct-schuko.html) (PIN122161200) — 1450 W continuous and 2100 W peak from the same new generation Documentation * Datasheet Inverter VE.Direct 250W – 1600W 230V (EN, PDF) (https://www.victronenergy.com/upload/documents/Datasheet-Inverter-VE.Direct-250W-1600W-230V-EN.pdf) * Manual Inverter VE.Direct 230V – HW15 (EN, HTML5) (https://www.victronenergy.com/media/pg/Inverter_VE.Direct_230V_-_HW15/en/index-en.html) * Manual Inverter VE.Direct 230V – HW15 (EN, PDF) (https://www.victronenergy.com/upload/documents/Inverter_VE.Direct_230V_-_HW15/106668-Inverter_VE_Direct__Smart_and_SUN-pdf-en.pdf) * ISO 9001 certificate (PDF) (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-EN.pdf) * VE.Direct HEX protocol Phoenix Inverter (EN, PDF) (https://www.victronenergy.com/upload/documents/VE.Direct-HEX-Protocol-Phoenix-Inverter.pdf) Videos * Did You Know – Reduce power consumption of an inverter in standby (EN) (https://www.youtube.com/watch?v=v0s0x0hf66I) Contact At 1150 W from 12 V, the cabling and the fuse determine what remains in practice. As an official Victron distributor, we supply from our own stock in Bodegraven and directly from the Victron Energy warehouse, and our engineers calculate the system for you. Contact us (https://www.top.systems/nl/contact/) for advice or a quotation. Specifications System voltage 12 Vdc Continuous power at 25 °C 1150 W Continuous power at 40 °C 1000 W Time-dependent power (cold start) 1200 W for 1 hour Peak power 1600 W for 15 s Output voltage 230 VAC ±3 %, adjustable 210 – 230 V Frequency 50 or 60 Hz ±0.1 %, adjustable Waveform Pure sine wave Input voltage range 9.2 – 17 V Low battery voltage shutdown 9.3 V, adjustable Restart and low battery voltage alarm 10.9 V, adjustable Battery charged detection 14 V, adjustable Dynamic shutdown Load-dependent, fully configurable Maximum efficiency 91 % No-load power 10 W No-load power in ECO mode 1 W ECO mode Yes; standard wake-up power 15 W, adjustable scanning interval Communicative VE.Direct AC output Schuko socket (CEE 7/4), 1 piece AC input No DC connection Screw terminals, max 35 mm² Remote on/off Yes, via two-pole plug Automatic changeover switch Filax Protection class IP21 Operating temperature -40 to +65 °C, fan cooling; We would be happy to provide you with more information about this product. Please contact
contact join us.
