SCHUKO 12/1600 230V VE Direct Converter
12/1600 230V VE.Direct Converter SCHUKO Applications The heaviest model in the VE.Direct series, operating at a system voltage that halves the cabling. 1450 W continuous is sufficient for a microwave, a hot plate, or tools, and 1600 W remains available for one hour. * 24 V trucks, work vans, and service vehicles * Motor yachts, work vessels, and larger sailboats * Holiday homes, chalets, and off-grid accommodations * Mobile workplaces and measurement setups with heavier loads * Backup for equipment that must continue operating during a power outage Power and starting behavior * 1450 W continuous at 25 °C, 1300 W at 40 °C * 1600 W for one hour (cold start) * 2100 W peak power for 15 seconds for starting currents of motors, pumps, and power tools * Pure sine wave, suitable for sensitive electronics * Full bridge with toroidal transformer; Short-circuit proof and protected against overheating due to overload or high ambient temperature * Maximum efficiency 91% ECO mode If the load drops below the set threshold, the inverter switches to standby and periodically scans whether there is demand again. The minimum generating power is 15 W by default and the scanning interval is adjustable. Consequently, the no-load power drops from 14 W to 2 W. The correct setting depends heavily on the type of load: inductive, capacitive, or non-linear. Expect a brief on-site adjustment. Battery monitoring and shutdown * Input voltage range 18.4 – 34 V * Low battery voltage shutdown default 18.6 V, adjustable * Restart and alarm at 21.8 V, battery charged detection at 28 V, both adjustable * Dynamic shutdown: the shutdown level follows the load, configurable per battery type in VictronConnect * Protected against short circuit, overload, over- and under-battery voltage, over-temperature, and excessive DC ripple voltage Do not use dynamic shutdown in an installation where other consumers are also connected to the same battery bank: the inverter cannot account for this load and will shut down prematurely with an undervoltage alarm. VE.Direct port * Read out and configure via VictronConnect on a smartphone or tablet using a VE.Direct Bluetooth Smart dongle * Connection to a PC via a VE.Direct-to-USB interface cable, or with a GX device * Configurable: output voltage 210 – 230 V, frequency 50 or 60 Hz, ECO threshold and scan interval, alarm and trip levels, dynamic trip curve per battery type * Monitoring of input and output voltage, load percentage, and alarms; firmware update via the app Connection and mounting * Schuko socket (CEE 7/4) on the device * DC side on screw terminals, maximum cable cross-section 25 mm²; battery cables are not included * Connection for an external on/off switch on the two-pole plug, or between the battery positive terminal and the left contact thereof * Battery alarm for excessive or low battery voltage, acoustic and visual, with relay for remote notification * Protection class IP21; Dry, indoor installation only * Operating temperature -40 to +65 °C with fan cooling; above 40 °C, power decreases by 1.25% per °C. Can be ordered directly with this * Victron VE.Direct Bluetooth Smart dongle (https://shop.top.systems/monitoring-controle/draadloos/victron-ve-direct-bluetooth-smart-dongle.html) (ASS030536011) — read out and configure via VictronConnect. Category: Monitoring & control > Wireless (https://shop.top.systems/monitoring-controle/draadloos/) At 24 V, over 65 A flows through the battery cables at full power. Select cross-section, crimp lugs, and fuse based on the cable length in the categories Battery cables (https://shop.top.systems/installatie/kabels/accu/), Crimp lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/), Fuses (https://shop.top.systems/beveiligen-schakelen/zekeringen/), and Fuse holders (https://shop.top.systems/beveiligen-schakelen/zekeringhouders/). Related products * Inverter 24/800 VE.Direct Schuko (https://shop.top.systems/omvormen-laden/omvormen-dc-ac/omvormer-24-800-ve-direct-schuko.html) (PIN241801200) — 650 W continuous and 1500 W peak Documentation * Datasheet Inverter VE.Direct 250W – 1600W 230V (EN, PDF) (https://www.victronenergy.com/upload/documents/Datasheet-Inverter-VE.Direct-250W-1600W-230V-EN.pdf) * Manual Inverter VE.Direct 230V – HW15 (EN, HTML5) (https://www.victronenergy.com/media/pg/Inverter_VE.Direct_230V_-_HW15/en/index-en.html) * Manual Inverter VE.Direct 230V – HW15 (EN, PDF) (https://www.victronenergy.com/upload/documents/Inverter_VE.Direct_230V_-_HW15/106668-Inverter_VE_Direct__Smart_and_SUN-pdf-en.pdf) * ISO 9001 certificate (PDF) (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-EN.pdf) * VE.Direct HEX Protocol Phoenix Inverter (EN, PDF) (https://www.victronenergy.com/upload/documents/VE.Direct-HEX-Protocol-Phoenix-Inverter.pdf) Videos * Did You Know – Reduce power consumption of an inverter in standby (EN) (https://www.youtube.com/watch?v=v0s0x0hf66I) Contact At 24 V, this unit delivers 1450 W with manageable cabling, but the battery bank must be able to handle the peak load. We calculate the capacity, cable cross-section, and fuse requirements for you and, as an official Victron distributor, supply from our own stock in Bodegraven and directly from the Victron Energy warehouse. Contact us (https://www.top.systems/nl/contact/) for advice or a quotation. Specifications System voltage 24 Vdc Continuous power at 25 °C 1450 W Continuous power at 40 °C 1300 W Time-dependent power (cold start) 1600 W for 1 hour Peak power 2100 W for 15 s Output voltage 230 VAC ±3 %, adjustable 210 – 230 V Frequency 50 or 60 Hz ±0.1 %, adjustable Waveform Pure sine wave Input voltage range 18.4 – 34 V Low battery voltage shutdown 18.6 V, adjustable Restart and low battery voltage alarm 21.8 V, adjustable Battery charged detection 28 V, adjustable Dynamic shutdown Load-dependent, fully configurable Maximum efficiency 91 % No-load power 14 W No-load power in ECO mode 2 W ECO mode Yes; standard operating power 15 W, adjustable scanning interval Communicative VE.Direct AC output Schuko socket (CEE 7/4), 1 piece AC input No DC connection Screw terminals, max 25 mm² Remote on/off Yes, via two-pole plug Automatic changeover switch Filax Protection class IP21 Operating temperature -40 to +65 °C, fan cooling; above 40 °C 1.25% power degradation per °C Humidity Maximum 95%, non-condensing Dimensions (hxwxd) 117 x 231 x 365 mm Weight 8.9 kg Housing Steel frame with plastic cover Safety standards EN-IEC 60335-1, EN-IEC 62109-1 EMCEN standards 55014-1, EN 55014-2, IEC 61000-6-1, IEC 61000-6-2, IEC 61000-6-3 Vehicle directive ECE R10-4 Brand Victron Energy Warranty 5 years We would be happy to provide you with more information about this product. Please contact us
contact join us.
