MultiPlus 12/800/35-16

MultiPlus 12/800/35-16

MultiPlus 12/800/35-16 Applications For motorhomes, boats, service vehicles, and small off-grid and backup installations where 230 V is required without overloading the generator. Powers cooling, microwave, tools, and electronics from the battery bank and automatically supplements limited shore or generator power. Pure sine wave inverter with UPS function 230 VAC ±2% ​​at 50 Hz ±0.1%, adjustable to 240 V and 60 Hz. Continuous 700 W at 25 °C, 650 W at 40 °C, and 400 W at 65 °C, peak power 1600 W. In the event of AC failure, the inverter takes over within 20 milliseconds. PowerControl Set the maximum shore or generator power with a Digital Multi Control panel. The device takes other AC loads into account and uses only the remaining power to charge, ensuring the source is not overloaded. PowerAssist: During peak load, the battery bank immediately supplements the deficit from the shore or generator connection. As soon as the load drops, the released power is used again for charging. This allows for a smaller shore connection or a lighter generator. Adaptive four-stage charger with second charging output * House battery charging current 35 A (up to 25 °C ambient temperature) * Separate 1 A trickle charge output for the starter battery * Absorption 14.4 V, float 13.8 V, storage mode 13.2 V * Battery temperature sensor included as standard * Suitable for wet, gel, AGM, and lithium batteries Parallel and three-phase connection Up to six units in parallel for more power, or three units in three-phase. For parallel and three-phase operation, an RJ45 splitter (ASS030065510) is required for 500, 800, and 1200 VA. Search mode With search mode enabled, no-load consumption drops by approximately 70%, from 7 W to 2 W. The inverter switches off at no or very low load and briefly tests every two seconds whether there is a load. Programmable relay Default setting as an alarm relay: the relay trips upon alarm or pre-alarm (inverter almost too hot, input ripple voltage almost too high, battery voltage almost too low). Configurable as a general alarm, DC undervoltage, or start/stop signal for a generator. Switching capacity 230 V/4 A AC, 4 A up to 35 VDC, and 1 A up to 60 VDC. Setup and configuration * DIP switches for external switch, charging voltage, inverter frequency, and search mode * External on/off/charger-only via three-pin connector * Extensive configuration with VictronConnect or VE.Configure via the MK3-USB Interface * VE.Bus Smart dongle for operation and data reading via smartphone Remote monitoring and control In combination with a communication center from the GX family, the system can be monitored and operated locally and via the internet on the VRM Portal – Victron Energy (https://vrm.victronenergy.com) and in the VRM app. Protections and housing Protected against output short circuit, overload, over- and under-battery voltage, over-temperature, 230 VAC on the inverter output, and excessive ripple voltage on the input. Steel/ABS housing, protection class IP21, fan-cooled, operating temperature -40 to +65 °C. Internal DC fuse 150 A, battery connection 25 mm², AC connection via G-ST18i connector. Can be ordered directly with this * Red battery cable 25mm² per meter (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KABRD0102500) (KABRD0102500) – category Battery cables (https://shop.top.systems/installatie/kabels/accu/) * Black battery cable 25mm² per meter (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KABZW0102500) (KABZW0102500) – category Battery cables (https://shop.top.systems/installatie/kabels/accu/) * Crimp eyelet 25mm² > M8 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=PSKABOG00026) (PSKABOG00026) – category Crimp lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Red insulation cap 25mm² (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP220N4V02) (ISKP220N4V02) – category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Black insulation cap 25mm² (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP220N4V14) (ISKP220N4V14) – category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Red heat shrink tubing 50cm for 16/25mm battery cable (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KRKR00112764) (KRKR00112764) – category Heat shrink tubing (https://shop.top.systems/installatie/accessoires-kabels/krimpkousen/) * Black heat shrink tubing 50cm for 16/25mm battery cable (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KRKZ00112764) (KRKZ00112764) – category Heat shrink tubing (https://shop.top.systems/installatie/accessoires-kabels/krimpkousen/) * MEGA-fuse fuse holder 2xM8 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ZEKHD0000200) (ZEKHD0000200) – category Fuse holders (https://shop.top.systems/beveiligen-schakelen/zekeringhouders/) * Victron MEGA-fuse fuse holder (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=CIP100200100) (CIP100200100) – category Fuse holders (https://shop.top.systems/beveiligen-schakelen/zekeringhouders/) * Victron Digital Multi Control 200/200A (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=REC020005010) (REC020005010) – category Control panels (https://shop.top.systems/monitoring-control/controlpanels/) * Victron Digital Multi Control 200/200A GX (90º) (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=DMC000200010R) (DMC000200010R) – category Control panels (https://shop.top.systems/monitoring-control/controlpanels/) * Victron Battery monitor BMV-702 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BAM010702000R) (BAM010702000R) – category Battery monitors (https://shop.top.systems/monitoring-controle/accumonitors/) * Victron Battery monitor BMV-702 Black (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BAM010702200R) (BAM010702200R) – category Battery monitors (https://shop.top.systems/monitoring-controle/accumonitors/) * Victron Battery Monitor BMV-712 Smart (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BAM030712000R) (BAM030712000R) – category Battery Monitors (https://shop.top.systems/monitoring-control/accumonitors/) * TS Enovations Isolation Monitor IMD3 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=SHP302501450-C) (SHP302501450-C) – Insulation guards category (https://shop.top.systems/beveiligen-switching/isolationbewakers/) * Victron VE.Bus Smart dongle (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ASS030537010) (ASS030537010) Related products * MultiPlus 12/500/20-16 (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/multiplus-12-500-20-16.html) (PMP121500000) * MultiPlus 12/1200/50-16 (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/multiplus-12-1200-50-16.html) (PMP122120000) * MultiPlus 12/800/35-16 Compact (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/multiplus-12-800-35-16-compact.html) (CMP121800000) Documentation * Datasheet MultiPlus 500VA – 2000VA (EN) (https://www.victronenergy.com/upload/documents/Datasheet-MultiPlus-500VA-2000VA-EN.pdf) * Manual MultiPlus 500VA – 1200VA (NL/EN/FR/DE/ES/IT) (https://www.victronenergy.com/upload/documents/Manual-MultiPlus-500VA-1200VA-EN-NL-FR-DE-ES-IT.pdf) * Dimensions MultiPlus 12V 24V 48V 800VA 120V/230V (https://www.victronenergy.com/upload/documents/MultiPlus-12-24-48V-800VA-120V-230V.pdf) * Declaration of Conformity MultiPlus 500VA – 2000VA (https://www.victronenergy.com/upload/documents/MultiPlus-500VA-2000VA-2022-07-04.pdf) * ECE R10-6 Certificate MultiPlus 12/800/35-16 (https://www.victronenergy.com/upload/documents/Certificate-Automotive-ECE-R10-6-MultiPlus-12-800-35-16-230V.pdf) * Victron Energy ISO 9001 Certificate (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-EN.pdf) Videos * Did You Know – You can update a MultiPlus Firmware using an Android Phone? (EN) (https://youtu.be/AEPmjkyg7UY) * How to set up BMV Battery Monitor for lead and lithium batteries (EN) (https://www.youtube.com/watch?v=mEN15Z_S4kE) Contact Unsure about the battery bank, cabling, or configuration? Our product specialists will be happy to calculate your installation with you and, as an official Victron distributor, deliver quickly from stock. Contact Top Systems (https://www.top.systems/nl/contact/). Specifications Continuous output power at 25 °C 800 VA / 700 W Continuous output power at 40 °C 650 W Continuous output power at 65 °C 400 W Peak power 1600 W House battery charging current 35 A Starter battery charging current 1 A Switching current 16 A PowerControl / PowerAssist Yes Input voltage DC 12 V (range 9.5 – 17 V) Output voltage AC 230 VAC ±2%, 50 Hz ±0.1% Input voltage AC (charger) 187 – 265 VAC, 45 – 65 Hz Charging voltage absorption / float / storage 14.4 / 13.8 / 13.2 V Maximum efficiency 92% No-load power 7 W No-load power in search mode 2 W Battery temperature sensor Yes Programmable relay Yes Communication port VE.Bus External on/off On / off / charger only Parallel and three-phase operation Yes, up to six units Internal DC fuse 150 A Battery connection 25 mm² AC connection G-ST18i connector Housing Steel/ABS Protection class IP21 Operating temperature -40 to +65 °C, fan-cooled Humidity Max. 95%, non-condensing Dimensions (hxwxd) 360 x 240 x 100 mm Weight 6.4 kg EAN 8719076038221 Standards EN-IEC 60335-1, EN-IEC 60335-2-29, EN 62109-1, ECE R10 We would be happy to provide you with more information about this product. Please contact contact join us.