MultiPlus-II 48/6500/100-50 230 Volt
MultiPlus-II 48/6500/100-50 230 Volt Applications The new model delivers more power per kilo and per dm³ and retains that power even at high ambient temperatures. Intended for energy storage with and without grid connection, emergency power, maritime and mobile installations, and heavy loads up to 6 kW continuous. PowerControl and PowerAssist Set the maximum grid, shore, or generator current; the remaining capacity goes to the battery charger so that the source does not become overloaded. During peak load, the battery bank immediately replenishes the deficit, and the reserve capacity is then used again for charging. With the optional external AC current sensor, this range extends up to 100 A. ESS and Feed-in Core component of a Victron ESS installation, combinable with MPPT solar chargers and grid-connected PV inverters. Using data from an external current sensor or energy meter, self-consumption is optimized and feed-in can be limited or blocked. Maximum apparent feed-in power 6 kW. Built-in protection against islanding. Power and time-limited output: 6 kW continuous at 25 °C, 5.7 kW at 40 °C, and 4.6 kW at 65 °C. After a cold start, 6.5 kW is available for 4 hours and 8 kW for 1 hour. The peak power is 11 kW for 1 minute. Two AC outputs. The main output operates uninterrupted and takes over within 20 milliseconds in the event of a mains failure or loss of shore or generator power. The 32 A auxiliary output is only energized as long as AC is present at the input and is intended for loads that must not discharge the battery bank, such as a water heater. Battery charger: Adaptive charging with absorption 57.6 V, trickle charging 55.2 V, and storage mode 52.8 V. Charging current 100 A at 25 °C and 95 A at 40 °C. Suitable for lithium, lead-acid, and zinc-bromine, among others, provided the charger is set according to the battery manufacturer's specifications. The battery temperature sensor is optional, item number ASS000001000. Parallel and 3-phase operation: Up to six identical units in parallel. Additionally, three units of the same model can be configured as a 3-phase system, and a maximum of six of these sets can be connected in parallel. Low self-consumption: No-load power 28 W, 18 W in AES mode, and 8 W in search mode. Programmable relay: Configurable for general alarm, DC undervoltage, or aggregate start/stop. Load capacity: 230 V / 4 A AC, 4 A to 35 V DC, and 1 A to 60 V DC. Configuration, monitoring, and control: Setup using VEConfigure via the MK3 USB interface or with the VictronConnect app. Available options for monitoring and control include a Cerbo GX or Ekrano GX communication center, a Digital Multi Control panel, a battery monitor, and the VE.Bus Smart dongle. The system can be monitored and adjusted remotely in the VRM Portal – Victron Energy (https://vrm.victronenergy.com) via a GX device with an internet connection. Available to order directly * Cable set 35mm² 1.5 m red and black M8-M8, KABSET010351 – go to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KABSET010351) | category Battery cables (https://shop.top.systems/installatie/kabels/accu/) * Battery cable red 35mm² per meter, KABRD0103500 – go to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KABRD0103500) | category Battery cables (https://shop.top.systems/installatie/kabels/accu/) * Battery cable black 35mm² per meter, KABZW0103500 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KABZW0103500) | category Battery cables (https://shop.top.systems/installatie/kabels/accu/) * Crimp cable lug 35mm² > M8, PSKABOG00036 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=PSKABOG00036) | category Crimp cable lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Crimp cable lug 70mm² > M8, PSKABOG00071 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=PSKABOG00071) | category Crimp cable lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Red insulation cap 35 / 50mm², ISKP222N4V02 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP222N4V02) | category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Insulation cap black 35 / 50mm², ISKP222N4V14 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP222N4V14) | category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Insulation cap red 70/95mm², ISKP232N4V02 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP232N4V02) | category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Insulation cap black 70/95mm², ISKP232N4V14 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP232N4V14) | category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Heat shrink tubing red 50cm for 35/50/70mm battery cable, KRKR01191955 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KRKR01191955) | category Heat Shrink Tubing (https://shop.top.systems/installatie/accessoires-kabels/krimpkousen/) * Black heat shrink tubing 50cm for 35/50/70mm battery cable, KRKZ01191955 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KRKZ01191955) | category Heat Shrink Tubing (https://shop.top.systems/installatie/accessoires-kabels/krimpkousen/) * Mega fuse holder M8 35-500A, ZEKHD0000805 – to the item (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ZEKHD0000805) | category Fuse holders (https://shop.top.systems/beveiligen-schakelen/zekeringhouders/) * Victron Cerbo GX MK2, BPP900450110 – to the article (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BPP900450110) * Victron Ekrano GX, BPP900480100 – to the article (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BPP900480100) * Victron VE.Bus Smart dongle, ASS030537010 – to the article (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ASS030537010) * Victron Digital Multi Control 200/200A, REC020005010 – to the article (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=REC020005010) | category Control panels (https://shop.top.systems/monitoring-controle/bedieningspanelen/) * Victron SmartShunt 500A/50mV, SHU050150050 – to the article (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=SHU050150050) | Category Battery monitors (https://shop.top.systems/monitoring-controle/accumonitors/) Related products * MultiPlus-II 48/5000/70-50, PMP482505010 – go to the article (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=PMP482505010) * MultiPlus-II 48/4500/55-32 230 Volt GX, PMP482406000 – go to the article (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/multiplus-ii-48-4500-55-32-230-volt-gx.html) * Quattro-II 48/5000/70-50/50, QUA482504010 – go to the article (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/quattro-ii-48-5000-70-50-50.html) Documentation * Datasheet MultiPlus-II Inverter/Charger, new models 230 V (EN) (https://www.victronenergy.com/upload/documents/Datasheet-MultiPlus-II-inverter-charger-4k-4k5-6k5-EN-.pdf) * Manual MultiPlus-II 4k, 4k5, 6k5, 10k 230V (EN) (https://www.victronenergy.com/upload/documents/MultiPlus-II_4k_4k5_6k5_230V/32424-MultiPlus-II___Quattro-II-pdf-en.pdf) * Manual MultiPlus-II 4k, 4k5, 6k5, 10k 230V (DE) (https://www.victronenergy.com/upload/documents/MultiPlus-II_4k_4k5_6k5_230V/32424-MultiPlus-II___Quattro-II-pdf-de.pdf) * ISO 9001 certificate (NL) (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-NL.pdf) Contact Unsure about the correct fuse, cable cross-section, or parallel and 3-phase configuration? Our product specialists would be happy to calculate your installation and help you think about the ESS configuration. Contact us (https://www.top.systems/nl/contact/). Specifications Nominal battery voltage 48 V Continuous output power at 25 °C 6 kW Continuous output power at 40 °C 5.7 kW Continuous output power at 65 °C 4.6 kW Time-limited power 1 (cold start) 6.5 kW for 4 hours Time-limited power 2 (cold start) 8 kW for 1 hour Peak power 11 kW for 1 minute Maximum battery charging current at 25 °C 100 A Maximum battery charging current at 40 °C 95 A Automatic transfer switch 50 A Maximum AC input current 50 A Auxiliary output Yes, 32 A Maximum apparent feed-in power 6 kW Input voltage range DC 38 – 60 V Output voltage 230 V AC ± 2 %, 50 Hz ± 0.1 % AC input voltage range 187 – 265 V AC, 45 – 65 Hz Charging voltage absorption / trickle / storage 57.6 / 55.2 / 52.8 V Maximum efficiency 96 % No-load power 28 W No-load power AES mode 18 W No-load power search mode 8 W Compatible battery chemistry Lithium, lead-acid, zinc-bromine and more Battery temperature sensor Optional, ASS000001000 External AC current sensor Optional, 100 A Programmable relay Yes, 230 V / 4 A AC; 4 A up to 35 V DC, 1 A up to 60 V DC Communication VE.Bus, 2x general communication ports, remote on/off Operating temperature -40 to +65 °C, fan-assisted cooling Maximum humidity 95 %, non-condensing Maximum altitude 4000 m, above 2000 m derating 1 % per 100 m Housing material Steel Protection class IP21 Battery connection M8 bolts 230 V AC connection Screw terminals 13 mm² Dimensions (hxwxd) 644 x 320 x 150 mm Weight 29 kg Safety standards EN-IEC 60335-1, EN-IEC 60335-2-29, EN-IEC 62109-1, EN-IEC 62109-2 Continuous power supply IEC 62040 Island protection IEC 62116 We would be happy to provide you with more information about this product. Please take
contact join us.
