Victron Centaur charger 12/30 (3) 90-265V AC

Victron Centaur charger 12/30 (3) 90-265V AC

Victron Centaur charger 12/30 (3) 90-265V AC Applications For yachts, workboats, and vehicles with a 12V installation and multiple battery banks. Charges starter, service, and bow thruster batteries simultaneously, remains permanently connected without excessive gassing, and is suitable for battery banks of 120-300 Ah. Three separate charging outputs The charger has three galvanically isolated outputs, allowing three battery banks to be charged simultaneously without interfering with one another. The 30 A charging current is distributed among the connected batteries; if only one battery bank is connected, the entire current goes to it. Three-step IUoU charging algorithm Fully automatic charging in bulk, absorption, and trickle. As soon as the charging current during absorption has dropped to approximately 70% of the nominal value, a four-hour timer starts, after which the charger switches to trickle charging. This allows the charger to remain permanently connected without a fully charged battery developing excessive gas. Adjustable to battery type * GEL, factory setting * AGM * Wet lead-acid batteries * Other mode for non-standard charging voltages * Adjustable via DIP switches behind the lower front panel Worldwide usability The input ranges from 90 to 265 V AC at 45 to 65 Hz and delivers full output power across the entire range. This allows the charger to operate on virtually any shore power network, including 120 V. The power factor is 1, ensuring minimal load on the shore power connection. Temperature compensation An internal sensor corrects the charging voltage by -2 mV/°C per cell. The charging voltage is reduced in a warm engine room and increased at low temperatures, ensuring the batteries receive the correct voltage under all conditions. Version for marine and mobile use * Aluminium housing with epoxy powder coating and drip shield * Acrylic-coated PCB against corrosion and moisture * Stainless steel mounting hardware * Ignition protected version * Forced cooling with a fan controlled by temperature and charging current * Built-in ammeter * Protected against output short circuit and overheating Related products * Victron Centaur charger 12/20 (3) 90-265V AC (https://shop.top.systems/omvormen-laden/acculaders/victron-centaur-lader-12-20-3-90-265v-ac.html) (CCH012020000) * Victron Centaur charger 12/40 (3) 90-265V AC (https://shop.top.systems/omvorm-laden/acculaders/victron-centaur-lader-12-40-3-90-265v-ac.html) (CCH012040000) * Victron Centaur charger 12/50 (3) 90-265V AC (https://shop.top.systems/omvorm-laden/acculaders/victron-centaur-lader-12-50-3-90-265v-ac.html) (CCH012050000) * Victron Centaur charger 12/60 (3) 90-265V AC (https://shop.top.systems/omvorm-laden/acculaders/victron-centaur-lader-12-60-3-90-265v-ac.html) (CCH012060000) Documentation * Datasheet Centaur Charger (https://www.victronenergy.com/upload/documents/Datasheet-Centaur-Charger-NL.pdf) (NL) * Centaur Charger Datasheet (https://www.victronenergy.com/upload/documents/Datasheet-Centaur-Charger-EN.pdf) (EN) * Centaur Charger Manual (https://www.victronenergy.com/upload/documents/Manual-Centaur-charger-EN-NL-FR-DE-IT.pdf) (NL, EN, FR, DE, IT) * Centaur Charger Dimensions (https://www.victronenergy.com/upload/documents/Centaur-Charger-1220-1230-2416.pdf) * Declaration of Conformity including UL 1236 (https://www.victronenergy.com/upload/documents/Centaur-Chargers-incl-UL1236-2022-07-04.pdf) (EN) * ISO 9001 certificate (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-NL.pdf) (NL) * ISO 9001 certificate (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-EN.pdf) (EN) Contact Are you unsure about the charging current for your battery capacity, the distribution across the three outputs, or the cable cross-section to the battery banks? Our technical advisors would be happy to calculate your installation with you. Contact us via top.systems/nl/contact (https://www.top.systems/nl/contact/). Specifications Battery voltage 12V Charging current 30 A Number of outputs 3, galvanically isolated Recommended battery capacity 120-300 Ah Input voltage AC90 – 265 V AC Input voltage DC90 – 400 V DC Input frequency 45 – 65 Hz Power factor 1 Charging characteristic 3-stage IUoU: bulk, absorption, trickle Absorption voltage 14.3 V Trickle voltage 13.5 V Temperature compensation -2 mV/°C per cell Battery types GEL, AGM, wet lead-acid, Other Ammeter Yes Cooling Temperature and current controlled fan Protections Output short circuit, overheating Operating temperature -20 to +60 °C Humidity Max. 95%, non-condensing Protection class IP20 Ignition protected Yes Housing Aluminum with drip shield AC connection Screw terminal 4 mm² (AWG6) Dimensions (hxwxd) 351 x 214 x 110 mm Weight 3.8 kg Safety EN 60335-1, EN 60335-2-29, UL 1236 EMCEN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3 Automotive ECE R10-5 Warranty 5 years We would be happy to provide you with more information about this product. Please contact us contact join us.