SCHUKO 48/800 230V VE Direct Converter
SCHUKO 48/800 230V VE.Direct Inverter Applications With 650 W continuous and 1500 W peak, even heavier equipment runs on this: microwave, kettle, or a circular saw. At 48 V, the DC current remains below 15 A, so 4 mm² battery cable is sufficient for short distances — a major difference compared to the same inverter at 12 V. * Off-grid and home battery systems at 48 V * Telecom locations, meter cabinets, and pump installations in rural areas * Holiday homes, chalets, and recreational homes without a grid connection * Larger vessels with an onboard 48 V battery bank * Backup for equipment that must continue operating during a power outage Power and starting behavior * 800 VA nominal; 650 W continuous at 25 °C, 560 W at 40 °C * 1500 W peak power for starting currents of motors, pumps, and power tools * Pure sine wave, suitable for sensitive electronics * Full bridge with toroidal transformer; short-circuit proof and protected against overheating due to overload or high ambient temperature * Maximum efficiency 91% ECO mode If the load drops below the set threshold, the inverter switches to standby and scans every 2.5 seconds by default to see if there is demand again. The minimum operating power is 15 W by default; both values are adjustable. Consequently, the no-load power drops from 9.5 W to 3 W. The correct setting depends heavily on the type of load: inductive, capacitive, or non-linear. Expect a brief on-site calibration. Battery monitoring and shutdown * Input voltage range 36.8 – 62.0 V * Low battery voltage shutdown default 37.2 V, adjustable * Restart and alarm at 43.6 V, battery charged detection at 56.0 V, both adjustable * Dynamic shutdown: the shutdown level follows the load, allowing the battery bank to continue utilizing under light load * Protected against short circuit, overload, over- and under-battery voltage, over-temperature, and excessive DC ripple voltage, with automatic restart VE.Direct port * Read out and configure via VictronConnect on smartphone or tablet with a VE.Direct Bluetooth Smart dongle * Connection to a PC via a VE.Direct-to-USB interface cable * Adjustable: output voltage 210 – 245 V, frequency 50 or 60 Hz, ECO threshold and search interval, alarm and shutdown levels * Monitoring of battery voltage, AC output voltage, load indication, and alarms Connection and mounting * Schuko socket (CEE 7/4) on the device * DC side on screw terminals, maximum cable cross-section 10 mm²; battery cables are not included * Minimum battery capacity 30 Ah * Recommended DC cable: 4 mm² up to 1.5 m, 6 mm² for 1.5 to 3 m * Internal DC fuse 40 A (BF1 58 V), replaceable; for a DC cable longer than 1.5 m, an additional fuse or DC circuit breaker close to the battery bank is mandatory * Connection for an external on/off switch on the two-pole plug, or between the battery positive terminal and its left contact * Can be mounted vertically or horizontally with four screws, minimum 10 cm clearance all around; IP21 applies only with flush mounting according to the manual; in other positions IP20 * Connecting the battery cables in reverse will cause the internal fuse to blow and may damage the device. Can be ordered directly with this * Victron VE.Direct Bluetooth Smart dongle (https://shop.top.systems/monitoring-controle/draadloos/victron-ve-direct-bluetooth-smart-dongle.html) (ASS030536011) — read out and configure via VictronConnect. Category: Monitoring & control > Wireless (https://shop.top.systems/monitoring-controle/draadloos/) * Red battery cable 6mm² per meter (https://shop.top.systems/assortiment/details/?webgroupfilter=14&artdetail=KABRD0100600) (KABRD0100600). Category: Installation > Cables > Battery (https://shop.top.systems/installatie/kabels/accu/) * Battery cable black 6mm² per meter (https://shop.top.systems/assortiment/details/?webgroupfilter=14&artdetail=KABZW0100600) (KABZW0100600). Category: Installation > Cables > Battery (https://shop.top.systems/installatie/kabels/accu/) * Battery cable red 6mm² 150 cm 1 x M8 (https://shop.top.systems/assortiment/details/?webgroupfilter=14&artdetail=KABRD061508M) (KABRD061508M). Category: Installation > Cables > Battery (https://shop.top.systems/installatie/kabels/accu/) * Battery cable black 6mm² 150 cm 1 x M8 (https://shop.top.systems/assortiment/details/?webgroupfilter=14&artdetail=KABZW061508M) (KABZW061508M). Category: Installation > Cables > Battery (https://shop.top.systems/installatie/kabels/accu/) * Crimp cable lug 6mm² > M6 (https://shop.top.systems/assortiment/details/?webgroupfilter=14&artdetail=PSKABOG00006) (PSKABOG00006). Category: Installation > Cable accessories > Crimp lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Crimp lug 6mm² > M8 (https://shop.top.systems/assortiment/details/?webgroupfilter=14&artdetail=PSKABOG00007) (PSKABOG00007). Category: Installation > Cable accessories > Crimp lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) Note: at 48 V, a fuse with a sufficiently high voltage class is required. Select this based on cable and installation in the categories Fuses (https://shop.top.systems/beveiligen-schakelen/zekeringen/) and Fuse holders (https://shop.top.systems/beveiligen-schakelen/zekeringhouders/). Related products * Inverter 24/800 VE.Direct Schuko (https://shop.top.systems/omvormen-laden/omvormen-dc-ac/omvormer-24-800-ve-direct-schuko.html) (PIN241801200) — the same inverter for a 24 V battery bank Documentation * Manual Inverter VE.Direct 250VA – 1200VA (NL, EN, FR, DE, ES, IT — PDF) (https://www.victronenergy.com/upload/documents/Manual-Inverter-VE.Direct-250VA-1200VA-EN-NL-FR-DE-ES-IT-.pdf) * Datasheet Inverter VE.Direct 250VA – 1600VA (EN, PDF) (https://www.victronenergy.com/upload/documents/Datasheet-Inverter-VE.Direct-250VA-1600VA-EN.pdf) * Dimensions Inverter VE.Direct 24V/48V 800VA (PDF) (https://www.victronenergy.com/upload/documents/Inverter-VE.Direct-24V-48V-800VA.pdf) * Declaration of Conformity Inverter VE.Direct 250VA – 1200VA (PDF) (https://www.victronenergy.com/upload/documents/Inverters-VE.Direct-250VA-1200VA-230V50Hz-and-110V60Hz-2023-10-11.pdf) * Safety Certificate IEC 60335-1 / AS-NZS 4736 – 800VA & 1200VA (PDF) (https://www.victronenergy.com/upload/documents/Certificate-Safety-IEC-60335-1-AS-NZS-4736-Phoenix-Inverter-VE.Direct-800VA-&-1200VA.pdf) * ECE R10-5 Certificate – Phoenix Inverter VE.Direct 24/800, 48/800 (PDF) (https://www.victronenergy.com/upload/documents/Certificate-Automotive-ECE-R10-5-Phoenix-Inverter-VE.Direct-24-800,-48-800.pdf) * ISO 9001 Certificate (PDF) (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-EN.pdf) * VE.Direct HEX protocol Phoenix Inverter (EN, PDF) (https://www.victronenergy.com/upload/documents/VE.Direct-HEX-Protocol-Phoenix-Inverter.pdf) Videos * Did You Know – Reduce power consumption of an inverter in standby (EN) (https://www.youtube.com/watch?v=v0s0x0hf66I) Contact At 48 V, this unit delivers 650 W continuously with slim cabling, but the battery bank must be able to handle the peak. As an official Victron distributor, we supply from our own stock in Bodegraven and directly from the Victron Energy warehouse, and our engineers calculate the system for you. Contact us (https://www.top.systems/nl/contact/) for advice or a quote. Specifications System voltage 48 Vdc Nominal power 800 VA Continuous power at 25 °C 650 W Continuous power at 40 °C 560 W Peak power 1500 W Output voltage 230 VAC ±3 %, adjustable 210 – 245 V Frequency 50 or 60 Hz ±0.1 %, adjustable Waveform Pure sine wave Input voltage range 36.8 – 62.0 V Low battery voltage shutdown 37.2 V, adjustable Restart and low battery voltage alarm 43.6 V, adjustable Battery charged detection 56.0 V, adjustable Dynamic shutdown Load-dependent, configurable Maximum efficiency 91 % No-load power 9.5 W No-load power in ECO mode 3 W ECO mode Yes; Standard wake-up power 15 W, standard search interval 2.5 s, both adjustable Communicative VE.Direct AC output Schuko socket (CEE 7/4), 1 piece AC input No DC connection Screw terminals, maximum 10 mm² Minimum battery capacity 30 Ah Recommended DC cable 4 mm² up to 1.5 m; 6 mm² at 1.5 – 3 m Internal DC fuse 40 A, type BF1 58 V, replaceable Remote on/off Yes, via two-pole plug Automatic changeover switch Filax or Multi Protection class IP21 (IP20 with different mounting position) Operating temperature -40 to +60 °C, fan cooling; above 40 °C 1.25% power degradation per °C Humidity Maximum 95%, non-condensing Dimensions (hxwxd) 105 x 216 x 305 mm Weight 5.5 kg Housing Steel frame with plastic cover Safety standards EN/IEC 60335-1, EN/IEC 62109-1 EMCEN standards 55014-1, EN 55014-2, IEC 61000-6-1, IEC 61000-6-3 Vehicle directive ECE R10-4, EN 50498 Brand Victron Energy Warranty 5 years We would be happy to provide you with more information about this product. Please contact us
contact join us.
