Victron Inverter 12/250 VE.Direct Schuko
Victron Inverter 12/250 VE.Direct Schuko. Powers 230V equipment with limited power consumption from a 12V battery bank: laptops, power tool battery chargers, lighting, and small measuring equipment. Suitable for commercial vehicles, motorhomes, boats, and small off-grid locations. The ECO mode limits self-consumption when nothing is switched on for extended periods, for example, overnight. Battery voltage: For 12V battery banks with an input range of 9.2-17V. At low battery voltage, the device switches off at 9.3V and restarts at 10.9V; the battery is considered full from 14.0V. All levels are adjustable. The output delivers 230 VAC ±3% at 50 Hz or 60 Hz. Power: Continuous power 200W at 25C and 175W at 40C, peak power 400W, nominal 250VA. Maximum efficiency 87%. The no-load consumption is 4.2W, and 0.8W in ECO mode. The unit is protected against short circuits, overload, excessive or low battery voltage, excessive temperature, and excessive DC ripple. Construction: Full bridge circuit with toroidal transformer, a design that Victron has been using in the Phoenix series for years. Internally, there are two 30A (ATOF 32V) DC fuses that are non-replaceable. Mounting: Mount on the floor, vertically against the wall with the fan at the bottom, or horizontally against the wall. IP21 applies only for floor mounting; otherwise, IP20 applies. Keep 10cm of clearance all around. DC connection via screw terminals up to 10mm². Minimum battery capacity 30Ah. Use 4mm² cable up to 1.5 meters and 6mm² from 1.5 to 3 meters. If the DC cable is longer than 1.5 meters, install a fuse or DC circuit breaker close to the battery bank. Communication Via the VE.Direct port, you set voltage, frequency, alarm levels, trip levels, dynamic tripping, and ECO mode using VictronConnect: on a computer with the Victron VE.Direct to USB interface (https://shop.top.systems/installatie/interface/victron-ve-direct-to-usb-interface.html), ASS030530010, or on a smartphone with the Victron VE.Direct Bluetooth Smart dongle (https://shop.top.systems/monitoring-controle/draadloos/victron-ve-direct-bluetooth-smart-dongle.html), ASS030536011. A two-pin connector is available for remote switching on and off. Can be ordered directly with this purchase: * Victron VE.Direct Bluetooth Smart dongle (https://shop.top.systems/monitoring-controle/draadloos/victron-ve-direct-bluetooth-smart-dongle.html), ASS030536011 * Victron Phoenix Inverter Control (for VE.Direct) (https://shop.top.systems/monitoring-controle/bedieningspanelen/victron-phoenix-inverter-control-voor-ve-direct.html), REC040010210R * Cable set 6mm² 1.5 m red and black M8 (https://shop.top.systems/installatie/kabels/accu/kabelset-6mm-1-5-mtr-rood-en-zwart-m8.html), KABSET010060 * Cable set 10mm² 1.5 m red and black M8 (https://shop.top.systems/installatie/kabels/accu/kabelset-10mm-1-5-mtr-rood-en-zwart-m8.html), KABSET010100 * Red battery cable 6mm² per meter (https://shop.top.systems/installatie/kabels/accu/accukabel-rood-6mm-per-meter.html), KABRD0100600 * Black battery cable 6mm² per meter (https://shop.top.systems/installatie/kabels/accu/accukabel-zwart-6mm-per-meter.html), KABZW0100600 * Crimp eyelet 6mm² > M8 (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/perskabeloog-6mm-m8.html), PSKABOG00007 * Red heat shrink tubing 50cm for 10mm battery cable (https://shop.top.systems/installatie/accessoires-kabels/krimpkousen/krimpkous-rood-50cm-voor-10mm-accukabel.html), KRKR00019548 * Heat shrink tubing black 50cm for 10mm battery cable (https://shop.top.systems/installatie/accessoires-kabels/krimpkousen/krimpkous-zwart-50cm-voor-10mm-accukabel.html), KRKZ00019548 * MEGA-fuse fuse holder 2xM8 (https://shop.top.systems/beveiligen-schakelen/zekeringhouders/mega-fuse-zekeringhouder2xm8.html), ZEKHD0000200 Related products * Inverter 24/250 VE.Direct Schuko (https://shop.top.systems/omvormen-laden/omvormen-dc-ac/omvormer-24-250-ve-direct-schuko.html), PIN241251200 Documentation * Manual Inverter VE.Direct 250VA-1200VA – Victron Energy (NL/EN) (https://www.victronenergy.com/upload/documents/Manual-Inverter-VE.Direct-250VA-1200VA-EN-NL-FR-DE-ES-IT-.pdf) * Datasheet Inverter VE.Direct 250VA-1600VA – Victron Energy (EN) (https://www.victronenergy.com/upload/documents/Datasheet-Inverter-VE.Direct-250VA-1600VA-EN.pdf) * Dimensions Inverter VE.Direct 250VA-375VA – Victron Energy (https://www.victronenergy.com/upload/documents/Inverter-VE.Direct-12V-24V-48V-250VA-375VA.pdf) * Declaration of Conformity – Victron Energy (https://www.victronenergy.com/upload/documents/Inverters-VE.Direct-250VA-1200VA-230V50Hz-and-110V60Hz-2023-10-11.pdf) * Safety Certificate IEC 60335-1 – Victron Energy (https://www.victronenergy.com/upload/documents/Certificate-Safety-IEC-60335-1-AS-NZS-4736-Phoenix-Inverter-VE.Direct-250-375-500VA.pdf) * Certificate ECE R10-6 – Victron Energy (https://www.victronenergy.com/upload/documents/Certificate-Automotive-ECE-R10-6-Inverter-VE.Direct-250VA,-375VA,-500VA.pdf) * VE.Direct HEX protocol Phoenix Inverter – Victron Energy (EN) (https://www.victronenergy.com/upload/documents/VE.Direct-HEX-Protocol-Phoenix-Inverter.pdf) * ISO 9001 certificate – Victron Energy (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-EN.pdf) Videos * Did You Know – Reduce power consumption of an inverter in standby – Victron Energy (EN) (https://www.youtube.com/watch?v=v0s0x0hf66I) Q&A Can I configure the inverter with my smartphone? Yes, with the Victron VE.Direct Bluetooth Smart dongle (https://shop.top.systems/monitoring-controle/draadloos/victron-ve-direct-bluetooth-smart-dongle.html), ASS030536011, on the VE.Direct port and the VictronConnect app. What is the minimum battery capacity? 30Ah. What cable cross-section is required? 4mm² up to 1.5 meters and 6mm² from 1.5 to 3 meters. Above 1.5 meters, an additional fuse or DC circuit breaker is required at the battery bank. How does ECO mode work? If the load drops below the set threshold (minimum 15W), the inverter goes into standby mode and checks by default every 2.5 seconds whether there is demand again. Consumption then drops to 0.8W. Can I switch the inverter on and off remotely? Yes, via the two-pole connector, with a switch, or with the Victron Phoenix Inverter Control (for VE.Direct) (https://shop.top.systems/monitoring-controle/bedieningspanelen/victron-phoenix-inverter-control-voor-ve-direct.html), REC040010210R. Does IP21 apply in every mounting position? No, IP21 only applies to ground mounting. For wall mounting, the protection rating is IP20. Feel free to contact us for advice on the right inverter, cabling, and protection for your installation. We are happy to help you find the right solution, from a single inverter to a complete system. Contact Top Systems (https://www.top.systems/nl/contact/). Specifications Battery voltage 12V Continuous power at 25C 200W Continuous power at 40C 175W Peak power 400W Nominal power 250VA Output voltage 230 VAC ±3% Frequency 50 Hz or 60 Hz ±0.1% Waveform Pure sine wave Input voltage range 9.2-17V Low battery voltage shutdown 9.3V, adjustable Restart and low battery voltage alarm 10.9V, adjustable Battery full detection 14.0V, adjustable Dynamic shutdown Load-dependent, adjustable Maximum efficiency 87% No-load consumption 4.2W No-load consumption ECO mode 0.8W Communication VE.Direct Remote on/off Two-pole connector AC output Schuko DC connection Screw terminals, max. 10mm² Internal DC fuse 2x 30A ATOF 32V, non-replaceable Minimum battery capacity 30Ah Protection class IP21 with bottom mounting, otherwise IP20 Safety EN-IEC 60335-1, EN-IEC 62109-1 EMCEN 55014-1, EN 55014-2 Dimensions (hxwxd) 86 x 165 x 260 mm Weight 2.4 kg EAN 8719076045205 We would be happy to provide you with more information about this product. Please contact us
contact join us.
