Victron MultiPlus 12/1200/50-16 120V VE.Bus

Victron MultiPlus 12/1200/50-16 120V VE.Bus

Victron MultiPlus 12/1200/50-16 120V VE.Bus Applications For installations operating on 120 V / 60 Hz: American yachts, imported motorhomes, expedition vehicles, and test setups. Powers 120 V equipment from the 12 V battery bank, recharges at 50 A from a 120 V shore connection, and takes over immediately in the event of a power outage. 120 V / 60 Hz version This unit delivers 120 VAC ±2% ​​at 60 Hz ±0.1% and charges on an AC input of 95 to 140 V, 55 to 65 Hz. It is therefore intended for installations with American mains voltage and not for the European 230 V grid. Pure sine wave inverter with UPS function. Continuous 1000 W at 25 °C, 900 W at 40 °C, and 600 W at 65 °C, peak power 2400 W. If the AC source fails, the inverter takes over within 20 milliseconds, ensuring connected electronics continue to operate. PowerControl: Set the maximum shore or generator current using a Digital Multi Control panel. The device takes other AC loads into account and uses only the remaining power for charging, preventing the source from becoming overloaded. PowerAssist: During peak load, the battery bank immediately supplements the deficit from the shore or generator connection. As soon as the load drops, the released power is used for charging. Adaptive four-stage charger with second charging output * House battery charging current 50 A (up to 25 °C ambient temperature) * Separate 1 A trickle charge output for the starter battery * Absorption 14.4 V, float 13.8 V, storage mode 13.2 V * Battery temperature sensor included as standard * Suitable for wet, gel, AGM, and lithium batteries Parallel and three-phase connection Up to six units in parallel for more power, or three units in three-phase. An RJ45 splitter (ASS030065510) is required for parallel and three-phase operation; the unit has one RJ45 port. Search mode With search mode enabled, no-load consumption drops by approximately 70%, from 13 W to 4 W. The inverter switches off at no or very low load and briefly tests every two seconds whether there is a load. Programmable relay Standard configuration as alarm relay: the relay trips upon alarm or pre-alarm (inverter nearly too hot, input ripple voltage nearly too high, battery voltage nearly too low). Configurable as general alarm, DC undervoltage, or start/stop signal for a generator. Switching capacity 4 A at 120 V AC, 4 A up to 35 VDC, and 1 A up to 60 VDC. Setting up and configuring * DIP switches for external switch, charging voltage, and search mode * External on/off/charger-only via three-pin connector * Extensive configuration with VictronConnect or VE.Configure via the MK3-USB Interface * VE.Bus Smart dongle for operation and data retrieval via smartphone Remote monitoring and control In combination with a communication center from the GX family, the system can be monitored and operated locally and via the internet on the VRM Portal – Victron Energy (https://vrm.victronenergy.com) and in the VRM app. Protections and housing Protected against output short circuit, overload, over- and under-battery voltage, over-temperature, 120 VAC on the inverter output, and excessive ripple voltage on the input. Steel/ABS housing, protection class IP21, fan-cooled, operating temperature -40 to +65 °C. Internal DC fuse 200 A, battery terminal 35 mm², AC connection via G-ST18i connector. Can be ordered directly with this * Red battery cable 35mm² per meter (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KABRD0103500) (KABRD0103500) – category Battery cables (https://shop.top.systems/installatie/kabels/accu/) * Black battery cable 35mm² per meter (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KABZW0103500) (KABZW0103500) – category Battery cables (https://shop.top.systems/installatie/kabels/accu/) * Crimp cable eyelet 35mm² > M8 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=PSKABOG00036) (PSKABOG00036) – category Crimp lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Red insulation cap 35 / 50mm² (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP222N4V02) (ISKP222N4V02) – category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Black insulation cap 35 / 50mm² (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ISKP222N4V14) (ISKP222N4V14) – category Insulation caps (https://shop.top.systems/installatie/accessoires-kabels/isolatiekappen/) * Red heat shrink tubing 50cm for 35/50/70mm battery cable (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KRKR01191955) (KRKR01191955) – category Heat shrink tubing (https://shop.top.systems/installatie/accessoires-kabels/krimpkousen/) * Black heat shrink tubing 50cm for 35/50/70mm battery cable (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=KRKZ01191955) (KRKZ01191955) – category Heat shrink tubing (https://shop.top.systems/installation/accessories-cables/shrinkstocking/) * MEGA-fuse fuse holder 2xM8 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ZEKHD0000200) (ZEKHD0000200) – category Fuse holders (https://shop.top.systems/beveiligen- Schakelen/fusehouders/) * Victron Digital Multi Control 200/200A (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=REC020005010) (REC020005010) – category Control Panels (https://shop.top.systems/monitoring-controle/bedieningspanelen/) * Victron Digital Multi Control 200/200A GX (90º) (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=DMC000200010R) (DMC000200010R) – category Control Panels (https://shop.top.systems/monitoring-controle/bedieningspanelen/) * Victron Battery Monitor BMV-712 Smart (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BAM030712000R) (BAM030712000R) – category Battery Monitors (https://shop.top.systems/monitoring-controle/accumonitors/) * Victron Battery Monitor BMV-712 Smart black (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BAM030712200R) (BAM030712200R) – category Battery Monitors (https://shop.top.systems/monitoring-controle/accumonitors/) * Victron Cerbo GX MK2 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=BPP900450110) (BPP900450110) * Victron VE.Bus Smart dongle (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=16&artdetail=ASS030537010) (ASS030537010) Related products * MultiPlus 12/1200/50-16 (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/multiplus-12-1200-50-16.html) (PMP122120000) * MultiPlus 12/800/35-16 (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/multiplus-12-800-35-16.html) (PMP121800000) * MultiPlus 12/1600/70-16 (https://shop.top.systems/omvormen-laden/omvormen-laden-combi/multiplus-12-1600-70-16.html) (PMP122160000) Documentation * Datasheet MultiPlus 120V Inverter/Charger 500VA – 1200VA (EN) (https://www.victronenergy.com/upload/documents/Datasheet-MultiPlus-500-1200VA-120V-EN.pdf) * Manual MultiPlus 12V 500-1200VA 120Vac (EN, HTML5) (https://www.victronenergy.com/media/pg/MultiPlus_12V_500-1200VA_120Vac/en/index-en.html) * Manual MultiPlus 12V 500-1200VA 120Vac (EN, PDF) (https://www.victronenergy.com/upload/documents/MultiPlus_12V_500-1200VA_120Vac/155314-MultiPlus_500-1200VA_120Vac-pdf-en.pdf) * Dimensions MultiPlus 12V 24V 48V 1200VA (https://www.victronenergy.com/upload/documents/MultiPlus-12V-24V-48V-1200VA.PDF) * ISO 9001 Certificate Victron Energy (https://www.victronenergy.com/upload/documents/ISO9001-certificate-2024-EN.pdf) Videos * Did You Know – You can update a MultiPlus Firmware using an Android Phone? (EN) (https://youtu.be/AEPmjkyg7UY) * How to set up BMV Battery Monitor for lead and lithium batteries (EN) (https://www.youtube.com/watch?v=mEN15Z_S4kE) Contact A 120 V installation requires careful coordination of cabling, protection, and battery bank. Our product specialists are happy to assist and inform you about the current delivery time of this special item. Contact Top Systems (https://www.top.systems/nl/contact/). Specifications Continuous output power at 25 °C 1200 VA / 1000 W Continuous output power at 40 °C 900 W Continuous output power at 65 °C 600 W Peak power 2400 W House battery charging current 50 A Starter battery charging current 1 A Switching current 16 A PowerControl / PowerAssist Yes Input voltage DC 12 V (range 9.5 – 17 V) Output voltage AC 120 VAC ±2%, 60 Hz ±0.1% Input voltage AC (charger) 95 – 140 V, 55 – 65 Hz Charging voltage absorption / float / storage 14.4 / 13.8 / 13.2 V Maximum efficiency 93% No-load power 13 W No-load power in search mode 4 W Battery temperature sensor Yes Programmable relay Yes Communication port VE.Bus, 1x RJ45 External on/off On / off / charger only Parallel and three-phase operation: Yes, up to six units Internal DC fuse: 200 A Battery connection: 35 mm² AC connection: G-ST18i connector Housing: Steel/ABS Protection class: IP21 Operating temperature: -40 to +65 °C, fan-cooled Humidity: Max. 95%, non-condensing Dimensions (HxWxD): 406 x 250 x 100 mm Weight: 8.2 kg EAN: 8719076058182 Standards: EN-IEC 60335-1, EN-IEC 60335-2-29, EN 62109-1, ECE R10-4 We would be happy to provide you with more information about this product. Please contact us contact join us.