Victron Phoenix Smart IP43 battery charger 12/50(3) 120-240V

Victron Phoenix Smart IP43 battery charger 12/50(3) 120-240V

Victron Phoenix Smart IP43 Battery Charger 12/50(3) 120-240V A 12 V shore power charger of 50 A for camper, boat or van with three separate battery banks, each on its own output. Bluetooth is built-in, so setup and reading are done via smartphone: no panel, no extra cabling. Three full-current outputs All three outputs deliver the full nominal charging current, allowing you to charge three battery banks independently. Handy on board where service bank, starter battery and bow thruster battery each have their own connection. Six-stage adaptive charging algorithm By default, the charger charges according to a 6-stage adaptive algorithm with absorption at 14.4 V, float at 13.8 V and storage at 13.2 V. In high mode, the absorption voltage goes to 14.7 V, and in lithium mode to 14.2 V using a 3-stage algorithm. The temperature compensation is -16 mV/°C. Bluetooth and VictronConnect Bluetooth is built-in. Using the VictronConnect app on your smartphone, you configure the battery type, charging current, and alarms, and read the charging status and history. Firmware updates are handled via the same app. Low current mode for small battery banks With low current mode, you halve the charging current to 25 A. This is intended for situations where the full current is too much for the connected battery or the available shore connection. VE.Direct and remote on/off Via the VE.Direct port, you connect the charger to a GX device or directly to VictronConnect. The two-pole remote on/off input enables switching from a panel or from a lithium battery management system. Input and housing Input voltage 85 – 250 Vac (full power from 100 Vac, startup from 90 Vac) at 45 to 65 Hz. The housing is made of aluminum in RAL 5012, with IP43 for the electronics and IP22 for the connection area. Operating temperature -20 to 60 °C at a maximum of 95% relative humidity, non-condensing. Protected against battery reverse polarity (internal fuse), output short circuit, and overtemperature. Order power cord separately. The charger is supplied without a power cord. Order the CEE 7/7 power cord (ADA010100100 (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=17&artdetail=ADA010100100)) separately. Can be ordered directly with this * Red battery cable 16mm² per meter (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=17&artdetail=KABRD0101600) – KABRD0101600 * Black battery cable 16mm² per meter (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=17&artdetail=KABZW0101600) – KABZW0101600 * Red battery cable 16mm² 150cm 1 x M8 (https://shop.top.systems/installatie/kabels/accu/accukabel-rood-16mm-150cm-1-x-m8.html) – KABRD161508M, found in the Battery Cables category (https://shop.top.systems/installatie/kabels/accu/) * Battery Cable Black 16mm² 150cm 1 x M8 (https://shop.top.systems/installatie/kabels/accu/accukabel-zwart-16mm-150cm-1-x-m8.html) – KABZW161508M, found in the category Battery Cables (https://shop.top.systems/installatie/kabels/accu/) * Crimp Cable Eyelet 16mm² > M6 (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/perskabeloog-16mm-m6.html) – PSKABOG00016, found in the category Crimp Cable Eyelets (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Crimp Cable Eyelet 16mm² > M8 (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/perskabeloog-16mm-m8.html) – PSKABOG00017, found in the category Crimp cable lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Crimp cable lug 16mm² > M10 (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/perskabeloog-16mm-m10.html) – PSKABOG00018, found in the category Crimp cable lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Crimp cable lug 16mm² > M12 (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/perskabeloog-16mm-m12.html) – PSKABOG00019, found in the category Crimp cable lugs (https://shop.top.systems/installatie/accessoires-kabels/perskabelogen/) * Power cord CEE 7/7 smart IP43/Skylla 2m (https://shop.top.systems/default.asp?pageid=88&webgroupfilter=17&artdetail=ADA010100100) – ADA010100100 Related products * Victron Phoenix Smart IP43 battery charger 12/50 (1+1) 120-240V (https://shop.top.systems/omvormen-laden/acculaders/victron-phoenix-smart-ip43-acculader-12-50-1-1-120-240v.html) – PSC125051095 * Victron Phoenix Smart IP43 battery charger 12/30 (1+1) 120-240V (https://shop.top.systems/omvormen-laden/acculaders/victron-phoenix-smart-ip43-acculader-12-30-1-1-120-240v.html) – PSC123051095 * Victron Phoenix Smart IP43 battery charger 12/30 (3) 120-240V (https://shop.top.systems/omvormen-laden/acculaders/victron-phoenix-smart-ip43-acculader-12-30-3-120-240v.html) – PSC123053095 Documentation * Smart IP43 Charger 120-240V Manual (English) (https://www.victronenergy.com/upload/documents/Smart_IP43_Charger_120-240V/109244-Smart_IP43_Charger_120-240V-pdf-en.pdf) * Datasheet Smart IP43 Charger 120-240V (English) (https://www.victronenergy.com/upload/documents/Datasheet-Smart-IP43-Charger-120-240V-EN-.pdf) * Dimensioning drawing Smart IP43 Charger (3) 120-240V (https://www.victronenergy.com/upload/documents/Smart-IP43-charger-(3)-120-240V.pdf) * Declaration of Conformity Smart IP43 Chargers (EU DoC RED) (https://www.victronenergy.com/upload/documents/Smart-IP43-Chargers-EU-DOC-RED.pdf) * Safety Certificate EN/IEC 60335-1 and -2 (English) (https://www.victronenergy.com/upload/documents/Certificate-Safety-EN-IEC-60335-1-2-Smart-IP43-Charger-120-240V.pdf) * Certificate AS/NZS 60335 (English) (https://www.victronenergy.com/upload/documents/Certificate-AZ-NZS-60335-Smart-IP43-Charger.pdf) Contact Are you unsure whether to choose the version with a starter battery outlet or the one with three outlets, or whether to consider the cable cross-section for this charging current? Our technical advisors are happy to help. Please contact us (https://www.top.systems/nl/contact/). Specifications Battery voltage 12 V Charging current 50 A Low current mode 25 A Outputs Three, each full current Absorption voltage 14.4 V (normal), 14.7 V (high), 14.2 V (lithium) Float voltage 13.8 V Storage voltage 13.2 V Temperature compensation -16 mV/°C Charging characteristic 6-stage adaptive, 3-stage for lithium Input voltage 85 – 250 Vac (full power from 100 Vac, startup from 90 Vac) Input frequency 45 – 65 Hz Power factor 1 No-load consumption 1 W Back current < 1 mA Bluetooth Built-in VE.Direct Yes Remote on/off Yes, two-pole connection Protections Reverse battery polarity (internal fuse), output short circuit, over temperature Operating temperature -20 to 60 °C Relative humidity Max. 95%, non-condensing Housing Aluminium, RAL 5012 Protection class IP43 electronics, IP22 connection area Dimensions (hxwxd) 180 x 249 x 116 mm Weight 2.7 kg Safety EN 60335-1, EN 60335-2-29 EMCEN 55014-1, EN 61000-6-3, EN 61000-3-2 Vibration IEC 68-2-6, 10-150 Hz / 1.0 G We would be happy to provide you with more information about this product. Please contact us contact join us.